What are the main technical indicators of an acceleration sensor?
Release time:
2024-11-12
[{"id": 1, "text": "Sensors are rather delicate components. Avoid excessive impacts and vibrations (dropping, striking, etc.) during use. During installation, ensure that they are correctly and firmly secured in the required location."}
IEPE accelerometers are widely used, and NI data acquisition cards also support IEPE sensors, so our device also uses IEPE sensors. Its main technical indicators are as follows:
1. Sensor Sensitivity: This is one of the most important indicators of an accelerometer. After purchasing the sensor, the data it provides usually gives a factory-tested standard value. For example: 50.1mV/g. It is worth noting that this value is usually given at a calibrated frequency of 80Hz or 160Hz.
2. Measurement Range: Choose a sensor that is as consistent as possible with the input range of the data acquisition card. For example: The maximum measurement range of this device is 100g, and the input range of the data acquisition card is ±5V, so choosing a sensitivity of 50mV/g can ensure that the maximum measurement reaches 100g (5000mV/50mV/g=100g).
3. Frequency Range: The frequency range (5% deviation) in which the sensor operates. This shows that the sensor's frequency response is indeed not flat.
4. Resonance Frequency: Each sensor has its own resonance frequency, which should be far from the operating frequency. Here it is given as: >35KHz (far from the maximum operating frequency of 10KHz).
5. In-band Resolution: The acceleration resolution within the operating frequency range.
6. Non-linearity: The non-linearity index of the sensor. 1% is already a very good indicator.
7. Transverse Sensitivity: Transverse sensitivity refers to the ratio of the output to the input vibration when the accelerometer is subjected to a vibration orthogonal to the sensitive axis. The ratio of transverse sensitivity to axial sensitivity is called the "transverse sensitivity ratio", which represents the quality of the piezoelectric accelerometer.
Sensors are relatively precise components. When using them, avoid excessive impact and vibration (dropping, tapping, etc.) as much as possible. At the same time, during installation, they should be correctly and firmly installed in the required position.
Related blog